Bashar
04-11-2011, 08:06 AM
Hi,
According to this post (http://www.lammle.com/discussion/showthread.php?t=399) about the latest errata, p. 365 has the following correction:
At the bottom of the page, under "Corp(config)#do show ip route" lines 7 and 8 contain errors. "Serial0/0/1" and "Serial0/0/0" have been reversed.
"Serial0/0/1" goes with "10.1.2.0" and "Serial0/0/0" goes with "10.1.3.0"
But looking at figure 6.9 (p.341) there seems to be nothing wrong with lines 7 and 8. Packets to the 10.1.2.0 network will actually be forwarded thru S0/0/0 (on the Corp router) and those for the 10.1.3.0 network will be forwarded thru S0/0/1 (on the Corp router) exactly as stated in the routing table in the bottom of page 365. I'm trying to understand this without any access to real Cisco equipment or even any simulators at this point so please correct me if I'm wrong. Your help is appreciated.
According to this post (http://www.lammle.com/discussion/showthread.php?t=399) about the latest errata, p. 365 has the following correction:
At the bottom of the page, under "Corp(config)#do show ip route" lines 7 and 8 contain errors. "Serial0/0/1" and "Serial0/0/0" have been reversed.
"Serial0/0/1" goes with "10.1.2.0" and "Serial0/0/0" goes with "10.1.3.0"
But looking at figure 6.9 (p.341) there seems to be nothing wrong with lines 7 and 8. Packets to the 10.1.2.0 network will actually be forwarded thru S0/0/0 (on the Corp router) and those for the 10.1.3.0 network will be forwarded thru S0/0/1 (on the Corp router) exactly as stated in the routing table in the bottom of page 365. I'm trying to understand this without any access to real Cisco equipment or even any simulators at this point so please correct me if I'm wrong. Your help is appreciated.