Official Lammle User Forum
|
|
|
#1
01-23-2008, 03:30 PM
|
|||
|
|||
Review ? #11
Should the answer not be Router1(config)#ipv6 router rip 1 or Router1(config-if)ipv6 rip 1 enable instead of Router1(config-if)#ipv6 router rip 1? The example routers were configured using ipv6 rip 1 enable on the interfaces on pages 759-60, but the explanation for question 11 on page 771 says that the ipv6 router rip number command is used on the interface. I'm guessing the book is wrong in either the example or the review, just not sure which.
|
|
#2
01-23-2008, 04:48 PM
|
|||
|
|||
|
According to Cisco, to enable RIPng for IPv6, the following command is used on an interface:
(config-if)# ipv6 rip name enable This is from the document located at http://www.cisco.com/univercd/cc/td/....htm#wp1027195 I take it that the explanation to the review question is incorrect, as is the answer, and the explanation on page 760 in the book is correct.
|
 |
| Bookmarks |
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Hybrid Mode
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 7th Edition, Chapter 1, Review Question 9 | bs_kwaj | Chapter 1: Internetworking | 4 | 09-28-2011 08:06 AM |
| Chapter 4 Review Questions | tztex | General Questions (Any Chapter) | 0 | 01-01-2011 02:55 PM |
| Chpt 2 Review Question #2 wrong answer | rcordell | Chapter 3: Introduction to TCP/IP | 3 | 10-27-2009 03:51 AM |
| Chapt 8 Review Answer 2 and 4 Typos | xponti | General Questions (Any Chapter) | 0 | 01-05-2009 06:35 AM |
| Chapt 4 Review Question in E-Book | xponti | General Questions (Any Chapter) | 1 | 01-04-2009 07:33 AM |
All times are GMT -5. The time now is 08:18 PM.