Official Lammle User Forum
RIP protocols-classfull routing and classless
I am in the process of learning CCNA certification.
I would like to have clarfication regarding the RIP Protocol.
as per the CCNA book,RIP protcols supports classfull routing.
As per my under standing,RIP supports classfull routing class full routing is ,all my network devices interfaces should be having the same sub net information,so that i can have a communication...
this information available in the CCNA study Guide-640-802age #384
but I have network set up ,like this,with Ip address of each interfaces as belongs to these network id(s)
192.168.1.0,192.168.1.64 and 192.168.1.193 etc..
with subnet mask address of 255.255.255.192
I think,all these address are beloning to classfull ip address...
I have configured RIP and i have used network id 192.168.1.0.
But i could see routing updates only in one router,other router doesnt show remote network address...could you please let me know,what could be the reason for not having the communication....
But it works in rip version 2
|Thread||Thread Starter||Forum||Replies||Last Post|
|EIGRP - RIP Redistribution||Titan||Routing||2||01-26-2011 11:51 AM|
|Comments on Classless Addressing||viral_thakkar||Routing & Switching||2||04-16-2010 03:52 AM|
|Default routing is confusing, help!!!||otto4u||Chapter 8: IP Routing||3||08-05-2009 12:46 PM|
|Problem with Rip routing Plz help me any body||Gopis||Routing||3||05-20-2009 08:18 PM|
|IP Classless and AD->Metric->Load Balancing?||BlackJackiv2008||Chapter 8: IP Routing||2||08-15-2008 02:20 AM|