Official Lammle User Forum
|
#1
10-06-2009, 09:37 PM
|
|||
|
|||
Configuring wireless interface
Hi, I'm using Packet Tracer 5.0 and I'm in chapter 6 on figure 6.9, trying to configure the wireless router 871W. However, I can't enter the command "dot11radio" in any interface to set the wireless configuration. Does anyone know if this command is available on the simulator?? Is there any wireless device on the simulator that I can configure, because all the wireless ones there is no way to configure them.
If not what can I do to practice this command If I don't have a router?? Thanks, Rocha 
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
Threaded Mode
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How can I add a wireless interface card to a router in GNS3 | Maged | Routing | 0 | 07-15-2011 01:51 AM |
| Frame Relay | E1or0 | Routing | 19 | 06-12-2011 11:08 AM |
| Lab 10.1 Access list Page 657 for CCNA | gfranco | Access Lists | 3 | 11-11-2010 12:57 PM |
| how do I route across vlans? | DonB | Switching | 6 | 11-16-2009 11:18 AM |
| Cisco’s New CCNP Wireless Certification | lammle | Announcements | 4 | 07-28-2009 06:33 AM |
All times are GMT -5. The time now is 02:13 PM.