Official Lammle User Forum
|
#1
07-26-2010, 03:31 PM
|
|||
|
|||
A question about Frame Relay in CCNA exam
Hello, I very would like to discuss with you about the following question:
TheFrame Relay network in the diagram is not functioning properly. What is thecause of the problem? A.The Gallant router hasthe wrong LMI type configured. B. Inverse ARP isproviding the wrong PVC information to the Gallant router. C.The S3 interface ofthe Steele router has been configured with the frame-relay encapsulation ietfcommand. D.The frame-relay mapstatement in the Attalla router for the PVC to Steele is not correct. E.The IP address on theserial interface of the Attalla router is configured incorrectly. The answer said that it is "D", I think the mapping in router Steele is not right neither, because the IP address in the mapping should be the destination address, but in the exhibit, the ip address in the mapping of Router Steele is his own ip address, so I think this is wrong, what you guys think about? 
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
Threaded Mode
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| frame relay topo question... | ciscodaze | CCNA Equipment | 5 | 08-14-2011 08:06 AM |
| Question about CCNA exam commands. | Passennato | Exams | 3 | 07-21-2011 02:51 AM |
| Frame Relay Mapping Question | Saman | Chapter 16: WANs | 1 | 05-08-2010 01:21 PM |
| CCNA Exam Lab Sim Question | Jimmy | Cisco® IOS | 8 | 12-23-2009 06:53 AM |
| New CCNA level Exams + CCNA Price Changes | Discover Cisco | Internetworking | 8 | 07-07-2008 08:30 PM |
All times are GMT -5. The time now is 05:38 AM.