Official Lammle User Forum
|
#1
09-01-2010, 12:50 PM
|
|||
|
|||
1811 WAN Interface/VSAT Modem
Hello...
I had a "funny" but serious experience today at a client's office. I had configured an 1811 wireless router, only to go and install. But there, I could NOT ping the Ethernet interface of the VSAT Modem. The IP addresses were correctly configured and both interfaces were in the same subnet. I even configured the same speed (auto/full duplex) on both interfaces, used both straight through and cross-over cables, all to no avail. Please can somebody help me? I want a solution to this issue. I configured the same subnet on my laptop and plugged directly to the Modem, and it worked perfectly. But its not working with the 1811 ISR FastEthernet 0 interface. Could it be an encapsulation mismatch? The router in use presently is a Mikrotik router and its working fine. Please help me out! Thanks for your usual useful contributions.
__________________
a.k 
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
Threaded Mode
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| WLC - console and modem cable | crissa | Questions and Comments | 1 | 02-16-2011 03:51 AM |
| Terminal Server - Modem | ynoadrive | CCNP Equipment | 5 | 10-08-2010 04:41 AM |
| Wan switching | swaminathan | Switching | 5 | 05-13-2010 03:47 AM |
| "encapsulation failed" incomplete ARP | Ray_Bcomplex | Internetworking | 10 | 03-06-2010 08:03 AM |
| Question about WAN links | AndreasB | Chapter 16: WANs | 2 | 06-03-2009 06:43 AM |
All times are GMT -5. The time now is 05:51 PM.