Official Lammle User Forum
Review question no.8 page 485
Which of the following are true regarding OSPF areas? (Choose three.)
You must have separate loopback interfaces configured in each area.
The numbers you can assign an area go up to 65,535.
The backbone area is also called area 0.
If your design is hierarchical, then you don’t need multiple areas.
All areas must connect to area 0.
F. If you have only one area, it must be called area 1.
is D a correct answer, because i understand that for the design to be hierarchical you need to divide a large network to small areas, you need multiple areas.
can someone explain please?
|Thread||Thread Starter||Forum||Replies||Last Post|
|7th Edition, Chapter 1, Review Question 9||bs_kwaj||Chapter 1: Internetworking||4||09-28-2011 08:06 AM|
|Page 105 Chapter 2 Review Question 5||dae26||Chapter 3: Introduction to TCP/IP||5||03-18-2011 11:16 AM|
|Network+ Study Guide errata?||kristini||Exams||49||04-14-2010 03:44 PM|
|Page 407 Review Question 1||Andrew||Chapter 8: IP Routing||1||11-27-2008 10:01 AM|
|Question on Page 330 (near the bottom of the page)||Pravin||Chapter 8: IP Routing||4||05-28-2008 12:27 PM|