Official Lammle User Forum
|
#1
03-16-2011, 07:47 AM
|
|||
|
|||
Distribute-list
So I am reading about the distribute-list command. here is what I found out about it. "distribute-list is applied to an interface using EIGRP. In EIGRP, a distribute-list will block route entries from entering the topology table.:
Why would I want to use a Distribute-list vs creating an ACL list do the following: access-list 100 deny ip 224.0.0.0 0.255.255.255 any and ip access-group 100 in 
|
| Bookmarks |
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Threaded Mode
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Page 631 Extended Access List Example 2 | dae26 | Chapter 12: Security | 3 | 02-01-2011 12:22 PM |
| Lab 10.1 Access list Page 657 for CCNA | gfranco | Access Lists | 3 | 11-11-2010 12:57 PM |
| Help with access list? | oneyo1984 | Access Lists | 6 | 03-30-2010 09:50 AM |
| Correct Access List Statement in NAT | alabedekenny | Network Address Translation | 5 | 02-11-2009 07:05 PM |
| Access list | kingabiodun2003 | Access Lists | 1 | 08-25-2008 05:56 AM |
All times are GMT -5. The time now is 08:17 AM.