Official Lammle User Forum
|
#1
05-28-2011, 11:57 AM
|
|||
|
|||
Sixth Edition, Page 461
Hi,
I have noticed this little possible typo a year ago, and I didn't see anyone reporting it—or maybe I didn't get the concept 100% right. On page 461, the output of the show ip ospf neighbor command for R3 and 871W says that the DR is R3, and BDR is 871W, while the 871W interface has a higher physical IP address, and there are no loopback interfaces set on both routers. This means that the 871W router should be the DR. Can anyone help? Cheers! Amr 
|
| Bookmarks |
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Threaded Mode
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Errata and updates for my 7th edition | lammle | Announcements | 97 | 01-26-2013 11:55 AM |
| 7th Edition - Page 548 Q10 | Lion66six | Chapter 10: Layer 2 Switching and STP | 2 | 11-28-2012 04:52 PM |
| Question on Sixth Edition , Page 462 | Kent | Chapter 9: EIGRP and OSPF | 8 | 09-09-2011 09:38 AM |
| 7th Edition - Page 617 | Lion66six | Chapter 12: Security | 6 | 05-08-2011 08:31 AM |
| Sixth Edition, CCNA, Ch 5, Page 255, Table 5.3 at "bit 8" in the table | fiveangels | Chapter 7: Managing a Cisco Internetwork | 0 | 01-12-2008 07:48 PM |
All times are GMT -5. The time now is 09:47 PM.