EIGRP ip route

[pcameron1]

I think i've followed the EIGRP section in the 7th edition book with no mistakes, but for some reason I'm left with a RIP route in the table, when I run show ip route. I believed enabling EIRGP would cause this route to go away, buit no luck so far... Has anyone seen this before?



CORP#show ip route
Codes: C - connected, S - static, I - IGRP, R - RIP, M - mobile, B - BGP
D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP
i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter area
* - candidate default, U - per-user static route, o - ODR
P - periodic downloaded static route
Gateway of last resort is not set
10.0.0.0/24 is subnetted, 6 subnets
C 10.1.1.0 is directly connected, Vlan1
C 10.1.2.0 is directly connected, Serial0/0/0
C 10.1.3.0 is directly connected, Serial0/0/1
C 10.1.4.0 is directly connected, Serial0/1/0
C 10.1.5.0 is directly connected, FastEthernet0/0
C 10.1.6.0 is directly connected, FastEthernet0/1
172.16.0.0/16 is variably subnetted, 2 subnets, 2 masks
R 172.16.0.0/16 [120/1] via 10.1.5.2, 00:00:15, FastEthernet0/0
D 172.16.10.0/24 [90/30720] via 10.1.5.2, 00:33:38, FastEthernet0/0
D 192.168.10.0/24 [90/2172416] via 10.1.2.2, 00:33:31, Serial0/0/0
[90/2172416] via 10.1.3.2, 00:33:30, Serial0/0/1
D 192.168.20.0/24 [90/2172416] via 10.1.2.2, 00:33:31, Serial0/0/0
[90/2172416] via 10.1.3.2, 00:33:30, Serial0/0/1
D 192.168.30.0/24 [90/2172416] via 10.1.4.2, 00:33:29, Serial0/1/0
D 192.168.40.0/24 [90/2172416] via 10.1.4.2, 00:33:29, Serial0/1/0
CORP#